---
title: "Business Connector: Tracing Mapping Connections 3.0"
id: "business-connector-tracing-mapping-connections-3-0"
project: "Knowledge Base"
url: "https://docs.sepasoft.com/articles/knowledge-base/business-connector-tracing-mapping-connections-3-0"
updated: 2026-07-23T18:08:44Z
---

# Business Connector: Tracing Mapping Connections 3\.0

There are various levels of logging available in Ignition Designer. When needed, you can switch Business Connector Action Block mapping parameters to 'Trace' and verify the mapping connections.

 * * *

 ## Start Trace on Mapping Parameters

1. In Ignition Designer, open diagnostics with: **Help**→ **Diagnostics**
2. Navigate to the **Logging Levels** tab.
3. Search for "***BC***" to filter for Business Connector related items.
4. Using the drop-down selectors on the right, set **...BCAction** and **...BCNode** to ***TRACE***, as shown below.
![](/resources/Storage/knowledge-base/business-connector-tracing-mapping-connections-3-0/image2022-12-19_15-44-36.png)
5. When the chart is run, the **Console** tab in **Diagnostics** will show the parameter mapping connections.

| ![Information](/resources/Storage/knowledge-base/Info.png) | Loggers are lazy loaded, If **...BCAction** and **...BCNode**aren't already present in the **Logging Levels** tab, go to the chart and click on the particular action block you want to monitor and Designer will load the loggers into its cache. They will then be visible in the list. |
| --- | --- |

![](/resources/Storage/knowledge-base/business-connector-tracing-mapping-connections-3-0/image2022-12-19_15-43-45.png)

 Example output:

![](/resources/Storage/knowledge-base/business-connector-tracing-mapping-connections-3-0/image2022-12-19_15-46-33.png)