Sepasoft MES Module Suite
Specifying Material Lots
To reference material-lot(s) from outside the batch recipe, set sub-parameters set the following sub-parameters and make sure the requirements are met.
Version specific:
 |
3.81.8 RC 1 and 3.81.8 Stable Release and later. |
Set sub-parameters
- Auto_Create_Lot = F
- Auto_Select_Lot = F
- Bypass_Quantity_Check = F
Make Sure to Meet these requirements:
- Lot must exist in the system prior to running the batch.
- Lot must have enough available quantity
Hold Conditions
- If these requirements are not met, the phase goes into Hold .
- If the quantity is exceeded the phase goes into Hold.
For info, see Hold Command| Batch Command-State Sequence
Material Lot Configuration in Material Resource Parameters | Batch Procedure
Sepasoft MES Module Suite